Snowtraveller rebuild

[Barrie2777]

The first production machine was the SnowTraveller with a West Bend powerbee engine. Due to poor performance the west bend engine was recalled and replaced with a 148 jlo. The clutches were also changed at this time to the Morse Chain Powerflo Transmission.

The following postings will be of my rebuild of this upgraded model.

[Barrie2777]

20200829_195206-600x800.jpg (77.85KiB)Viewed 16545 times

This base and all the other parts was aquired in a trade. Although a rebuild has been started it is all wrong so i must cut and rebuild from square one.

[Barrie2777]

A few missing parts. Track support rails and a dash with serial number 1123.

[Barrie2777]

PhotoPictureResizer_200830_143342754-600x800.jpg (159.83KiB)Viewed 16537 times

The Snowtraveller dash was the only one that had a rope guide tube.

[Barrie2777]

PhotoPictureResizer_200830_144450755-600x800.jpg (114.83KiB)Viewed 16537 times

These skis were removed from the seater for this machine. If anyone wants a pair of undestructable skis, they are yours!!

Im installing a wooden pair.

[Barrie2777]

PhotoPictureResizer_200830_145536140-600x800.jpg (155.62KiB)Viewed 16537 times

There is many things to undo including this hinge reinforcement.

[Barrie2777]

20200916_133621-600x800-600x800.jpg (120.29KiB)Viewed 16492 times

This is the starting point for this SnowTraveller.

[Barrie2777]

20200925_195830-800x600.jpg (119.77KiB)Viewed 16430 times

An afternoon of welding

[Barrie2777]

Front fender support

20201003_194436-600x800.jpg (102.22KiB)Viewed 16343 times

Rear fender support for snowtravellee

20201003_194500-600x800.jpg (102.56KiB)Viewed 16343 times

The rear fender support on the SnowTraveller bends down to the center of the cogs. This is much lower than any other model. The front fender support remain tge same for all models

[Barrie2777]

20201025_195801-800x600.jpg (97.59KiB)Viewed 16225 times

Waiting for the new deck