200

[husskifan]

I DO LOIKE FLUID FILM AND HAVE NEVER HEARD OF WURTH PRODUCTS I WILL CHECK THEM OUT THANKS

[snocatpete]

wurth is a big company they have every thing from nuts and bolts to paint "rattle cans" to tools and all kinds of chemicals. I have used many other products of theirs and been very happy with them!

[snocatpete]

the engine is in need of a complete disassemble and careful inspection. It does turn over and seems to have good compression the wiring is a typical mess and the muffler and bracket will need welding repairs. I start by removing the muffler, clutch and fan shroud

[snocatpete]

wiring mess, broken muffler and a mess on the engine from loose exhaust bolts and no exhaust gasket

[snocatpete]

removing the clutch is a standard procedure remove the bolt ,remove outer half ,remove inner half from crankshaft.

[snocatpete]

using this tool to remove inner half of clutch from CS

[snocatpete]

next I removed the fan shroud something like this left unchecked could cause a serious over heating problem especially in spring time with higher ambient air temps

[snocatpete]

compressed air and blow gun cleaned all the stuff out of there ! next its finish disassembling and into the varsol bath for a good cleaning

[Barrie2777]

An important point about clutch removal is the clockwise rotation to undo the outer sheave. Too many guys try the anticlockwise rotation and strip those fine threads and invent a new problem.

[Barrie2777]

Can you give more details of the use of the puller for the inner sheave? Inner sheavve removal is usually problematic.