hus-ski 200 issue

A place to ask all your questions about Hus Skis or just a great place to spread a little of that Yellow Pride.
Post Reply
blackhorse51
Posts:15
Joined:Fri Nov 15, 2013 10:25 pm
hus-ski 200 issue

Post by blackhorse51 » Fri Dec 27, 2013 1:49 pm

Hi everyone,

Just wondered if anyone had any ideas why my hus-ski starts, idles and sounds fine, but after 10 minutes of so, just dies right out as if there is no gas. Almost like it gets good and warm and fails. Starts after it sits awhile. I rebuilt the carb, cleaned out ports, new gas filter, do I have the adjustments wrong? pumps fine,

thanks

Murray

User avatar
math
Posts:33
Joined:Sat Jun 02, 2012 11:22 am
Location:Trois-rivieres QC

Re: hus-ski 200 issue

Post by math » Sat Dec 28, 2013 6:08 pm

I had a snowblower that had the same problem... The problem was the coil. it was starting really good and then, after maybe 5 minutes it was dying, like your hus-ski. some times those old coils stop working when they get heated by the engine. Check if you still have spark, and if not, i think you will have to change the coil.

Mathieu

blackhorse51
Posts:15
Joined:Fri Nov 15, 2013 10:25 pm

Re: hus-ski 200 issue

Post by blackhorse51 » Sun Dec 29, 2013 2:03 am

Thanks,

Is there a special flywheel puller that works for the JLO 152??

User avatar
fap67
Posts:223
Joined:Tue Oct 06, 2009 5:02 pm

Re: hus-ski 200 issue

Post by fap67 » Sun Dec 29, 2013 9:24 am

blackhorse51 wrote:Thanks,

Is there a special flywheel puller that works for the JLO 152??
Yes, the one that you need has 30mm threads, 1.5mm thread pitch, right hand male threads, here is a link to one that is the correct size. I have never ordered from this place, I just did a google search for: flywheel puller 30mmx1.5 and this is one that came up. Be careful when searching for one, some have female threads and sometimes there may be a left hand thread one available too. Hope this helps.
http://www.atvparts.co.nz/flywheel-pull ... -2250.html

blackhorse51
Posts:15
Joined:Fri Nov 15, 2013 10:25 pm

Re: hus-ski 200 issue

Post by blackhorse51 » Sun Dec 29, 2013 11:05 pm

Thanks

Post Reply