Snowtraveller rebuild
- Barrie2777
- Posts:1547
- Joined:Tue Mar 04, 2008 9:17 pm
- Location:Arundel Quebec
The first production machine was the SnowTraveller with a West Bend powerbee engine. Due to poor performance the west bend engine was recalled and replaced with a 148 jlo. The clutches were also changed at this time to the Morse Chain Powerflo Transmission.
The following postings will be of my rebuild of this upgraded model.
The following postings will be of my rebuild of this upgraded model.
- Barrie2777
- Posts:1547
- Joined:Tue Mar 04, 2008 9:17 pm
- Location:Arundel Quebec
Re: Snowtraveller rebuild
This base and all the other parts was aquired in a trade. Although a rebuild has been started it is all wrong so i must cut and rebuild from square one.
- Barrie2777
- Posts:1547
- Joined:Tue Mar 04, 2008 9:17 pm
- Location:Arundel Quebec
Re: Snowtraveller rebuild
A few missing parts. Track support rails and a dash with serial number 1123.
- Attachments
-
- 20200830_100801-800x600.jpg (105.72KiB)Viewed 17532 times
- Barrie2777
- Posts:1547
- Joined:Tue Mar 04, 2008 9:17 pm
- Location:Arundel Quebec
Re: Snowtraveller rebuild
The Snowtraveller dash was the only one that had a rope guide tube.
- Barrie2777
- Posts:1547
- Joined:Tue Mar 04, 2008 9:17 pm
- Location:Arundel Quebec
Re: Snowtraveller rebuild
Im installing a wooden pair.
- Barrie2777
- Posts:1547
- Joined:Tue Mar 04, 2008 9:17 pm
- Location:Arundel Quebec
Re: Snowtraveller rebuild
There is many things to undo including this hinge reinforcement.
- Barrie2777
- Posts:1547
- Joined:Tue Mar 04, 2008 9:17 pm
- Location:Arundel Quebec
Re: Snowtraveller rebuild
This is the starting point for this SnowTraveller.
- Barrie2777
- Posts:1547
- Joined:Tue Mar 04, 2008 9:17 pm
- Location:Arundel Quebec
Re: Snowtraveller rebuild
An afternoon of welding
- Barrie2777
- Posts:1547
- Joined:Tue Mar 04, 2008 9:17 pm
- Location:Arundel Quebec
Re: Snowtraveller rebuild
The rear fender support on the SnowTraveller bends down to the center of the cogs. This is much lower than any other model. The front fender support remain tge same for all models
- Barrie2777
- Posts:1547
- Joined:Tue Mar 04, 2008 9:17 pm
- Location:Arundel Quebec
Re: Snowtraveller rebuild
Waiting for the new deck