I'm trying to tear down the engine in my 502. I was able to get the jug off, but am unable to get the flywheel off. Usually there are 3 small threaded holes where you could attach a puller, but this one doesn't.
Also was wondering about a clutch puller.
Engine Tear Down Help
Its No Longer "Just A Hobby" 
68 Diablo 502
68 AC Panther
70 AC Panther 295
71 Gilson 420
71 Poloron Tornado
71 AC Panther 399 WideMouth
68 Diablo 502
68 AC Panther
70 AC Panther 295
71 Gilson 420
71 Poloron Tornado
71 AC Panther 399 WideMouth
-
Go Go Diablo
- Site Admin
- Posts:1831
- Joined:Fri Feb 22, 2008 12:47 am
- Location:Sobieski, Wisconsin
- Contact:
Re: Engine Tear Down Help
This is a picture of the flywheel puller we use. It's 40mm thread screws on where the recoil hub was unscrewed.
The clutch puller is threaded into the bore of the clutch. If your clutch is not threaded, then you can tap it out. 7/8' fine.
Both pullers are available on the parts page of gogodiablo.com.
Bruce
- Flywheel Puller 02.JPG (60.84KiB)Viewed 3157 times
- Primary.JPG (44.16KiB)Viewed 3157 times
Bruce
Too many Diablos and parts to count.
Yamaha 600 SX
Yamaha 600 SX