Bolens Diablo Rouge and Hus Ski Discussion Forums

Hi all,

Bruce A from up in British Columbia has to remake his handlebars for his 444 reconstruction. He emailed me and asked

"I will need to repair mine by welding in pieces. Could you please let me know what angle from horizontal the bars tip up towards the driver."

Could someone share some pictures and dimensions?

Thanks,

Bruce

I have a sketch with dimensions and angles but it won't reduce for uploading. Can I fax it to anyone?

Barrie

You can fax it to me at 705-337-5353 and i'll scan it and then put it on the site for our friend in BC

Rock

It is scanned but wont reduce below 675 kb.

If all else fails, let me know and I'll get you Bruce's address and you can send it to him.

The other Bruce

With the hinge rod as a point of reference, there is a section of pipe 16" long which slopes up 3 degrees before the bend for the handlebars. The handlebar bend is 13.5 degrees and the pipe is 12 " long. This description is from a side view. The 12" length includes the lateral bend for the handlebar. The handlebar should be 30" from the floor with the tracks installed. Hope this helps, pending the submission of the sketch I sent to Rock.

Hi

Did not had time to chec the fax at work today but will get it for sure tomorrow morning

Rock

Hello

I was able to scan it at a smaller piece but not sure if it's clear enough

Rock

I would like to thank all of you who responded to my question re handle bar angle
The information was very helpful.
Thanks
BMA