Page 1 of 1
Setting timing 200A
Posted: Wed Dec 09, 2009 5:06 pm
by cmd
Hi guys, I found a coil for my 200A and am now trying to get it running, I took a guess on the timing and don't know if I am right but I would love to hear how you are supposed to do it as i cannot find any markings.
Re: Setting timing 200A
Posted: Wed Dec 09, 2009 10:13 pm
by Barrie2777
Did you remove the stator plate?
Re: Setting timing 200A
Posted: Thu Dec 10, 2009 8:29 am
by cmd
yes, it has been completely apart
Re: Setting timing 200A
Posted: Thu Dec 10, 2009 5:26 pm
by Barrie2777
Before you remove the stator plate, it is recommended to take a screwdriver and make a scratch from the stator plate to the frame which holds it. At the time of reassembly, you match up the scratch marks and have your original position. Assuming you did not do this, you will have to judge your initial position by the srcatch marks around the fixing screws.
Re: Setting timing 200A
Posted: Fri Dec 18, 2009 11:33 am
by cmd
Ok, might have to set a timing wheel to it. Thanks