Bolens Diablo Rouge and Hus Ski Discussion Forums

Hi all,

I got this request from Bill L in Norway, Wisconsin today. Bill has a 200A. Can anyone answer this question?

I need info on adjusting the clutch. The driven clutch has a spring that controls the tension on the movable clutch disc. On my rig, the adjustable portion has a saw cut through the threaded portion perpendicular to the shaft. The end of the housing is tapped and has a small set screw that I assume is intended to lock the adjustment in position. Unfortunately, I cannot get the set screw tight enough to hols the adjustment.

When I operate the clutch, the adjustable portion screws down tight. I assume this is not right.

Any suggestions on clutch adjustment and how to lock it in position? Any help you can offer will be most appreciated.

I have never given that set screw any thought but some how I doubt that it could exert enough sideways pressure on the fine threads of the post, to hold against the forces of the clutch. I am guessing that your spring is incorrect. When removed from the clutch , the spring is about 8 inches high making it very difficult to install the retaining cup. Does your machine advance when you feed fuel? or does it sit in place until the clutch spins in, then takes off?