Setting timing 200A

cmd · Post by **cmd** » Wed Dec 09, 2009 5:06 pm

Hi guys, I found a coil for my 200A and am now trying to get it running, I took a guess on the timing and don't know if I am right but I would love to hear how you are supposed to do it as i cannot find any markings.

Barrie2777 · Post by **Barrie2777** » Wed Dec 09, 2009 10:13 pm

Did you remove the stator plate?

cmd · Post by **cmd** » Thu Dec 10, 2009 8:29 am

yes, it has been completely apart

Barrie2777 · Post by **Barrie2777** » Thu Dec 10, 2009 5:26 pm

Before you remove the stator plate, it is recommended to take a screwdriver and make a scratch from the stator plate to the frame which holds it. At the time of reassembly, you match up the scratch marks and have your original position. Assuming you did not do this, you will have to judge your initial position by the srcatch marks around the fixing screws.

cmd · Post by **cmd** » Fri Dec 18, 2009 11:33 am

Ok, might have to set a timing wheel to it. Thanks

Bolens Diablo Rouge and Hus Ski Discussion Forums

Setting timing 200A

Re: Setting timing 200A

Re: Setting timing 200A

Re: Setting timing 200A

Re: Setting timing 200A