Page 1 of 1
Fuel inlet
Posted: Mon Feb 02, 2009 7:23 pm
by catman
Are the 90 Deg inlet plastic fuel strainers for the Tilson carbs still available.
I have found the scew in fuel filters but I would like to use those strainer types with the inlet on the side profile.
Re: Fuel inlet
Posted: Mon Feb 02, 2009 8:54 pm
by Go Go Diablo
I don't know where you can buy the plastic covers, but I think I might have a couple available.
Bruce
Re: Fuel inlet
Posted: Mon Feb 02, 2009 10:08 pm
by Barrie2777
I have about a dozen. I'll give you one this weekend if I don't have to tow your "red machine" home.
Re: Fuel inlet
Posted: Tue Feb 03, 2009 7:31 am
by Roy Teske
Looks like warm weather for Saturday guys. Hoods will be up for vapor lock. See you there! Roy
Re: Fuel inlet
Posted: Tue Feb 03, 2009 5:19 pm
by catman
HA HA Barrie ....just remember your 4:1 odds of braking down before me.
PLUS I have BEER to survive on..
I found the problem I had last year... a plug that holds a small steel ball fell out in my carb.
If You could bring one for the run I'll Buy it from Ya.. A
Chris
Re: Fuel inlet
Posted: Tue Feb 03, 2009 5:34 pm
by Barrie2777
Last year set the precedent that the owner is not the recipient of the award, but that the driver takes all honors for the machine. I think I will drive my 400, as for the other three machines.........................?
Re: Fuel inlet
Posted: Tue Feb 03, 2009 5:42 pm
by catman
I hope it's not too warm or I be taking my hood off. There are no vents on the 500 !!
Chris