Page 1 of 1
Handles on the seater
Posted: Thu Jun 12, 2008 8:20 pm
by Rock
Hi
Is there suppose the have any handles on the seater? By the looks of it there was some handles on each side of the seater.
Tks
Rock
Re: Handles on the seater
Posted: Thu Jun 12, 2008 8:34 pm
by cdnprairie
Hi Rock,
As far as I am aware, the handles are made of approx 1/2" diameter tubing, running along both sides of the seater approx 18" and wrapping around the rear of the seater just where the seater tubing bends upward.
Ken
Re: Handles on the seater
Posted: Thu Jun 12, 2008 8:39 pm
by Rock
Hi Ken
Tks for the info. Would you have spare handles that you would like to sell. I don't have any on my seater and it's going on a show in July.
Rock
Re: Handles on the seater
Posted: Thu Jun 12, 2008 8:42 pm
by Barrie2777
I believe that the model 500 didn't have side handles.
Re: Handles on the seater
Posted: Thu Jun 12, 2008 8:45 pm
by cdnprairie
Rock,
No I don't but but I don't think that it would be hard to bend some tubing and weld it on. I can take a photo of my seater and sent it to you so you can see the handle.
Ken
Re: Handles on the seater
Posted: Thu Jun 12, 2008 8:49 pm
by Go Go Diablo
Rock,
Barrie is correct, the 500s did not come original with the handle bars around the seat. If you want one, I think I have an extra 502/3 ski seater frame I'd consider swapping.
Re: Handles on the seater
Posted: Thu Jun 12, 2008 8:50 pm
by cdnprairie
Hi Barrie,
Rock, Barrie is right. Just checked my 500 manual and it does not indicate handles on the seater, however the 502/3 does.
Ken
Re: Handles on the seater
Posted: Thu Jun 12, 2008 8:52 pm
by Rock
That would be great Ken. Here is my email address.
arguindon@ntl.sympatico.ca
By the looks of my seater they use to be some handles for it because Theres some holes on each side for handles.
Rock