Hus Ski Sno Shoo? Diverco Inc Question

[Go Go Diablo]

Hi all,

Was down mid state today picking up a Diablo and Hus Ski ski seater from a fella and on the trailer under the fresh snow we had was a Sno Shoo made by Diverco in Milwaukee. The guy told me he was told that it was part of Bolens and made from Hus Ski parts. It looks like a Hus Ski frame (with a fiberglass or plastic fender) and is built to adapt a Honda Motorcycle to it by taking the back wheel off and mounting the cycle forks to the tractor. The track drive shaft looks to be driven from a chain from the cycle output sprocket. A large front ski looks to go in place of the front wheel. I looked on line and found a reference to 1967 Sno Shoo.

Anybody ever see one of these and know what it's worth?

100_4666.JPG (31.62KiB)Viewed 3124 times

100_4667.JPG (31.88KiB)Viewed 3124 times

100_4664.JPG (36.51KiB)Viewed 3124 times

Snow Shoo.JPG (6.9KiB)Viewed 3114 times

[plowman]

Hey There
That's an interesting find .I'm pretty sure there was an article in Popular Mechanix about this contraption.If my memory is any good,I would say this was around 1970-72.Perhaps these hot-rods were from left-over parts.
Jim

[Barrie2777]

Here is what I found out about the Sno-Shooo...it,s a Cycle Sno Shoo it,s was built in
> 1967 by Diversco Inc Milwaukee Wiscons.That was a twin track system like the
> Hus-> Ski. It fit on motorcycles Bridgestone, Honda, Suzuki, and Yamaha, from
> 80cm3 to 305cm3 The pub say in Cycle World magazine that you can install
> this in 20 min, and ride it to 60mi/h it,s was selling $449.95 $U.S....that 60 mi/hr is scarey just reading about it going that fast!!!!