600 clutch

A place to ask all your questions about Hus Skis or just a great place to spread a little of that Yellow Pride.
Post Reply
User avatar
1965 Hus-Ski
Posts: 32
Joined: Thu Sep 10, 2015 6:48 pm

600 clutch

Post by 1965 Hus-Ski » Sun Dec 09, 2018 8:18 pm

I was wondering about the secondary clutch on the 600’s that is hand adjustable. My quess is power or speed depending on where it’s set at ? Also does anybody have a measurement from the center of clutches ( primary to secondary)? I live in south central wi. So not much deep snow riding. Thanks.
One piece at a time

User avatar
Posts: 1526
Joined: Tue Mar 04, 2008 9:17 pm
Location: Arundel Quebec

Re: 600 clutch

Post by Barrie2777 » Mon Dec 10, 2018 7:51 am

By screwing the adjusting knob you creat more resistance for the secondary to open. This translates to higher engine revs to get the clutch to start opening. So yes....you loose some speed to get power. This is the same for the 200, 200-A and 400 which all have the same clutch.

User avatar
Posts: 372
Joined: Sun Feb 07, 2010 8:39 pm

Re: 600 clutch

Post by snocatpete » Thu Dec 13, 2018 7:15 pm

Also it is recommended NOT to screw the adjusting knob in more than 5/8" .
As far as the centre to centre measurement I've not found an actual measurement in any Hus-ski manual other than the 444 with the Salsbury 500 clutch which is 10 1/4"
As Barrie says 200, 200A, 400 and 600 use the same clutch so on my 200A with the secondary clutch set for the correct drive chain tension and the muffler centred in the exhaust port and approximately 1" deflection on the drive belt the centre to centre measurement I end up with is 10 3/4". So depending on the length of the belt you are using, that measurement will vary.
Also there is an offset measurement for these clutches. I've included some photos. I hope this helps.
IMG_5399.JPG (115.91 KiB) Viewed 454 times
IMG_5397.JPG (80.23 KiB) Viewed 454 times
IMG_5379.JPG (94.92 KiB) Viewed 454 times

Post Reply