Engine Tear Down Help

A place for all your Diablo Rouge Questions or just a place to shoot the bull about those little Red Devils.
Post Reply
User avatar
Woodro
Posts:6
Joined:Mon Mar 14, 2011 7:49 pm
Location:Kiel WI
Engine Tear Down Help

Post by Woodro » Wed Mar 16, 2011 9:12 am

I'm trying to tear down the engine in my 502. I was able to get the jug off, but am unable to get the flywheel off. Usually there are 3 small threaded holes where you could attach a puller, but this one doesn't.
Also was wondering about a clutch puller.
Its No Longer "Just A Hobby" :)
68 Diablo 502
68 AC Panther
70 AC Panther 295
71 Gilson 420
71 Poloron Tornado
71 AC Panther 399 WideMouth

User avatar
Go Go Diablo
Site Admin
Posts:1830
Joined:Fri Feb 22, 2008 12:47 am
Location:Sobieski, Wisconsin
Contact:

Re: Engine Tear Down Help

Post by Go Go Diablo » Wed Mar 16, 2011 4:36 pm

This is a picture of the flywheel puller we use. It's 40mm thread screws on where the recoil hub was unscrewed.
Flywheel Puller 02.JPG
Flywheel Puller 02.JPG (60.84KiB)Viewed 2264 times
The clutch puller is threaded into the bore of the clutch. If your clutch is not threaded, then you can tap it out. 7/8' fine.
Primary.JPG
Primary.JPG (44.16KiB)Viewed 2264 times
Both pullers are available on the parts page of gogodiablo.com.

Bruce
Too many Diablos and parts to count.
Yamaha 600 SX

Post Reply