What kind of choke plate are you running?

A place for all your Diablo Rouge Questions or just a place to shoot the bull about those little Red Devils.

What kind of choke plate are you running?

Postby Schoobytwo (Bruce) » Wed Mar 01, 2017 9:19 pm

I've had a Diablo in the shop for a while that has always been a challenge to get started. The typical Diablo is 4 to 6 pulls with the choke full closed and throttle full open until the motor fires. Then open the choke and again with full throttle, a few more pulls and it starts. Easy Peasy!

This darn Diablo I could pull and pull and then all of a sudden, it would fire up and practically take off right out of my hands. Not the typical starting as noted above. Went through the carb several times. Went through the ignition several times. Same thing.

Then I got to looking at the choke plate :idea:

DSC05134.JPG
DSC05134.JPG (146.84 KiB) Viewed 167 times


The choke plate the HR3A and HR14A should have is the plate on the left which has no holes in it. I occasionally see a carb with the plate in the middle with the single small hole and some others with the plate on the right which has a much larger hole. Guess which plate this Diablo had in it? Grrrrrrrrrrrrrr.... :evil: The plate on the right.

I took that plate off and installed a plate without holes and problem solved.

And when I think of this, it makes perfect sense. The Diablo Hirth Motor needs full choke (and I mean a full choke) to pull gas into the motor. With the large hole in the throttle plate, it was like my choke was not full closed. So when I pulled and pulled and pulled and finally got enough gas into the motor, it started and immediately was lean enough to take off.

I hope this helps someone else who may be struggling to start their Diablo.

Bruce
Too many Diablos and parts to count.
Yamaha Apex (it outruns the Diablo for sure)
Yamaha 600 SX
User avatar
Schoobytwo (Bruce)
Site Admin
 
Posts: 1707
Joined: Fri Feb 22, 2008 12:47 am
Location: Sobieski, Wisconsin

Return to Questions & Discussions about Diablos

Who is online

Users browsing this forum: No registered users and 1 guest

cron