CLUTCH PULLER

Use this area to have discussions and swap information regarding Diablos or Hus Skis!
Post Reply
User avatar
huuksnatch
Posts:75
Joined:Fri Aug 01, 2008 1:19 pm
Location:Calumet MI
CLUTCH PULLER

Post by huuksnatch » Mon Feb 03, 2014 4:43 pm

I need a clutch puller for my 252 engines. Anyone know where I can buy one from?
-Steve

husskifan
Posts:98
Joined:Mon Jan 12, 2009 12:12 pm

Re: CLUTCH PULLER

Post by husskifan » Thu Feb 06, 2014 12:32 pm

I MADE A PULLER I WILL GET YOU THE SPECS TOMMOROW, START THE PENETRATING OIL TO GET THE BOLT OUT AND SO IT WILL START WORKING ON THE SHAFT.

jrs_333
Posts:11
Joined:Sat Feb 01, 2014 10:15 am

Re: CLUTCH PULLER

Post by jrs_333 » Fri Feb 07, 2014 9:37 am

I beleive my crank shaft seal is bad. So how does a Hus Ski clutch come off? Do you need a clutch puller? Can any one send a picture?
Thanks..
Jay

jrs_333
Posts:11
Joined:Sat Feb 01, 2014 10:15 am

Re: CLUTCH PULLER

Post by jrs_333 » Tue Feb 11, 2014 8:46 pm

husskifan, did you send the clutch puller info? I'm going to throw a 295 on my 600 for a weekend old dog run. I'm running with a little more horspower..He..He.. Just to let everyone know they do fit but its tight.

jrs_333

husskifan
Posts:98
Joined:Mon Jan 12, 2009 12:12 pm

Re: CLUTCH PULLER

Post by husskifan » Thu Feb 13, 2014 1:56 pm

TAKE THE CENTER BOLT OUT OF THE CLUTCH GET A 7/8-14 TAP AND TAP THE INSIDE OF THE BORE NOW FILL THE HOLE WITH PENETRATING OIL AND LET IT SET NOW GET A 7/8-14 BOLT 5 INCHES LONG THREADED ALL THE WAY TO THE HEAD. GRIND OFF THE FIRST 1 1/2 INCHES OF THE THREADS SO ONLY THE THREADS NEAR THE HEAD OF THE BOLT REMAIN ROUND THE END OF THE BOLT OVER SO YOU WILL NOT DAMAGE THE END OF THE CRANK SHAFT. ONCE YOU THINK THE OIL HAS DONE ITS JOB INSERT THE BOLT AND START TIGHTENING A LITTLE BIT AT A TIME IT SHOULD COME OFF PRETTY EASY AN IMPACT WORKS BEST BUT DO NOT TRY ALL IN ONE SHOT MOST OF THESE CLUTCHES HAVE BEEN ON FORTY PLUS YEARS SO TAKE YOUR TIME. GOOD LUCK

jrs_333
Posts:11
Joined:Sat Feb 01, 2014 10:15 am

Re: CLUTCH PULLER

Post by jrs_333 » Tue Feb 18, 2014 8:40 am

hussskifan, I'll try that. Thanks for the info.
jrs_333

Post Reply