Getting a 200A going again.

These posts document restoration experiences of our members
RobertM
Posts:13
Joined:Sun Nov 14, 2021 9:00 am
Re: Getting a 200A going again.

Post by RobertM » Tue Nov 30, 2021 9:10 pm

-
Attachments
I08dn7J.jpg
I08dn7J.jpg (29.7KiB)Viewed 236 times
SNv3HE5.jpg
SNv3HE5.jpg (39.64KiB)Viewed 236 times

RobertM
Posts:13
Joined:Sun Nov 14, 2021 9:00 am

Re: Getting a 200A going again.

Post by RobertM » Fri Dec 03, 2021 7:23 pm

Made a few more pieces to the puzzle. Rebuilt the engine bolt brackets from stainless. Little bit each day.
Attachments
D2MNBII.jpg
D2MNBII.jpg (18.49KiB)Viewed 218 times
cHLJYSp.jpg
cHLJYSp.jpg (23.27KiB)Viewed 218 times

User avatar
Schoobytwo (Bruce)
Site Admin
Posts:1811
Joined:Fri Feb 22, 2008 12:47 am
Location:Sobieski, Wisconsin
Contact:

Re: Getting a 200A going again.

Post by Schoobytwo (Bruce) » Fri Dec 03, 2021 8:11 pm

I like the idea you have about making the motor mounts out of bar stock with studs rather than trying to wrestle your arm under the chassis to tighten a nut or a bolt. When I did a 200, I did just the opposite and put the nuts downward. It worked really well.

Thank you for sharing all your cool ideas Robert!
DSC06745.JPG
DSC06745.JPG (138.56KiB)Viewed 217 times
DSC06750.JPG
DSC06750.JPG (140.02KiB)Viewed 217 times
Too many Diablos and parts to count.
Yamaha 600 SX

RobertM
Posts:13
Joined:Sun Nov 14, 2021 9:00 am

Re: Getting a 200A going again.

Post by RobertM » Sun Dec 05, 2021 10:37 pm

.
Attachments
4fIj50s.jpg
4fIj50s.jpg (22.32KiB)Viewed 207 times
eo57dZB.jpg
eo57dZB.jpg (25.04KiB)Viewed 207 times

Post Reply